Conic Sections in 3D

Slice a double cone with a plane — circle, ellipse, parabola, hyperbola

← Back to Home
Ellipse
θ = 35° · e = 0.66
Drag to rotate · scroll to zoom · right-drag to pan
35°
2.5
0.0

True shape of the slice

Seen face-on, looking straight at the cutting plane

Measurements

SectionEllipse
Eccentricity e0.66
Major axis—
Minor axis—
Apex → plane—

What is a conic section?

Take two cones meeting at their tips and slice through them with a flat plane. The edge of the cut is always a conic section — and which one you get depends only on how steeply the plane is tilted.

The rule

The cone's half-angle is 30° (the angle between its axis and a slant side), so the critical tilt is 60°.

θ = 0° → circle

0° < θ < 60° → ellipse

θ = 60° → parabola (the plane is parallel to a slant side)

θ > 60° → hyperbola

Formulas

This cone is x² + z² = y²/3.

Eccentricity: e = sin θ / cos 30°

e < 1 ellipse, e = 1 parabola, e > 1 hyperbola.

Eccentricity does not depend on how far the plane is from the apex — that only changes the size of the slice.

How to use

• Drag to rotate the double cone, scroll to zoom, right-drag to pan.

• Sweep Tilt θ past 60° and watch the ellipse break into a hyperbola.

• Height and Shift slide the plane; they change the size of the slice, never its type.

• Press Through apex to see the degenerate cases.

• The small panel shows the cut shape as it truly is, viewed face-on.

Degenerate slices

When the plane passes exactly through the apex the curve collapses: a point (from an ellipse), a single line (from a parabola) or two crossing lines (from a hyperbola).

Did you know?

Apollonius of Perga named these curves around 200 BC. Two thousand years later Kepler found that planets travel on ellipses with the Sun at one focus, while some comets swing past on parabolic or hyperbolic paths.

Satellite dishes and car headlights are parabolic because a parabola sends every ray that arrives parallel to its axis through one single point.

About This Math Simulation

Slice a double cone with a tiltable plane to produce circles, ellipses, parabolas and hyperbolas. Adjust tilt, height and shift, then read eccentricity, axis lengths and the true shape of the cut.

6 views · Math · Free interactive simulation